The next photo shows the 2 bolts holding the cable shifter in place. We need to remove these 2 bolts to gain access to the area where the input speed sensor is located. Once the bolts are removed just move the cable assembly out of the way. The red arrows point to the 2 bolts.
The next photo shows the new sensor in place. I
had to dig out the caked in sand around the housing and blow it out with compressed air so that it was a clean area to work with.
The red arrow points to the single 10 mm mounting bolt.
In my case, the old unit must have been leaking as there was oil in the connector/boot assembly.
Reconnect your cable and reassembly everything. I took the car for a test run and did not see any further issues. I hope these instructions and photos were helpful to someone else beside me.
The car has about 240,000 kms on it.
Cheers...
2 comments:
Do you by chance have a part number for the speed sensor? I am getting the same PO715 error code on my 2000 Sonata.
THanks
Rob
rcjay272@hotmail.com
I just bought one for my 2000 Sonata V6 from the Hyundai dealer in town. The part number is 42620-39051. Good luck!
Post a Comment